Comand aps ntg4 firmware update how to#
Comand aps ntg4 firmware update install#
Comand aps ntg4 firmware update update#

Comand aps ntg4 firmware update install#

New release moved to USB install rather than 3x DVD install. AM)crazyrr Wrote: Hallo, i have a W204 (2012) with NTG4.5 Comand Online (Version 1). USB install is also much faster at approx 1 hour *** 2017 Version 17. Comand Aps Ntg4 Firmware Software Number From Comand Aps Ntg4 Firmware Download Trainsignal Windows Is it possible to upgrade the Firmware from Rev. Note that map PIN codes are not refundable, please ensure you have the correct VIN number ** ** Note, we will now supply V17 2018 on a USB stick, which we have officially/properly downloaded from Mercedes, they are no longer releasing maps on disks and V16 was the last release on DVD. This is the European map install set for NTG4.5 vehicles (i.e vehicles in the list below with COMAND which have an SD-Card slot on the front) ** You will need to purchase a map PIN code for your vehicle in addition to these disks - see the Related Products section below, and don't forget to send us your VIN number. And that's strange why the open close button not works. Download Bunyi Bel Sekolah Otomatis Gratis. The left button to inlcine the screen works. If it's glk specific then updating software to a 'c class specific ' may active open close screen button (right button of the switch). But I wonder if it's glk specific or all c class have it. (2 buttons) If you have any idae, please say me have you the link 'off or close screen ' when you are in 'systeme', I get it and I can close the screen with it and continue to listen music or navi.

Comand aps ntg4 firmware update update#

You have to eject all discs and SD CARD!! And it will abort!! I search a software update for ntg4 2010 version, but it seems to come from glk, I fitted it to c class, all works good, but I can't use the swith to open close the screen, I think that's because it's a glk programmed unit, and software update may permiss open close screen with the switch under the screen. They should insert the disc immediately upon start up of the COMAND and the COMAND should start reading the data and take the update. The dealer should have an update disk and be able to update it.

Comand aps ntg4 firmware update how to#

Any ideas on how to get out of this loop? Dealer kids have not seen anything like this. Both of those just reboot the unit back to the software upgrade sequence. I've tried a soft reboot - pressing 5, hold for a sec then press 3 and also pressing the ON button for about 20 sec. After about 10 sec, if I do not press ABORT it will give the following message: Error on Update Please remove disc and press CCE Error Info on Main(00001201) Parser Error - CD-Info not found 14 CD INFO not found I have now idea what button CCE is. When I press the ABORT the unit powers down and then starts all over again.

It has 3 buttons on the bottom of the screen, START (greyed out) DETAILS (greyed out) and ABORT (lights up). Do I have an Audio 20 or COMAND Mercedes entertainment system. So now when it boots up it goes right into software upgrade mode. W212 E350 Software Updates Mercedes-Benz Owners Forums. Works pretty good, except that while I was goofing around looking through the engineering screens (end call + # + 1) I ended up starting the software upgrade sequence by mistake when I meant to back out of the screen. Hi Guys, I have a 2010 W212 E350 with the NTG4 COMAND set up.